This course provides you guidance on how to integrate your PowerFlex 753 or 755 drive into a system that includes:

Throughout the course, you will have the chance to use a variety of hardware and software tools, including:

Prerequisites

To successfully complete this course, the following prerequisites are required:

Working knowledge of electricity, and knowledge of electrical and industrial safety (including PPE requirements and safe practices)
Completion of the PowerFlex 750-Series Startup and Configuration course (CCA182 or CCA182-EL)
Knowledge of Logix5000 system fundamentals and basic programming skills:
- Creating a new project
- Adding I/O
- Working with tags
- Writing and testing ladder logic that includes bits, timers and other common instructions
- Uploading, downloading, and going online, through one or more of the following methods:
  - Completion of the Studio 5000 Logix Designer Level 1: Logix 5000 System Fundamentals course (CCP146 or CCP146-EL)
  - Experience programming basic Logix5000 control systems or above

Who Should Attend

This course is intended for individuals who need to add PowerFlex 750-Series drives to an Integrated Architecture system.

Adding PowerFlex 750-Series Drive to a Studio 5000 Logix Designer Project
Locating and Modifying PowerFlex 750-Series Data from a Studio 5000 Logix Designer Project
Integrating a PowerFlex 750-Series Drive with a Logix5000 Controller
Adding PowerFlex 750-Series Faceplates to a FactoryTalk View ME Application
Operating a PowerFlex 750-Series Drive in an Integrated Architecture System